Home Page > Pneumatic > Air Preparation Units > FRY Series Air Preparation Units > FRY 1 Series Air Preparation Units >

FRY 1 Series Air Preparation Units

Specifications
» G 1" air inlet and outlet ports.
» High flow and rate and efficiency.
» Precision pressure adjustment.
» Semi-automatic and automatic drain options.
» Long life.

Technical Specifications

Technical Specifications of F 1" Filter

Standards: ISO 5782 Filter standard

Operating Pressure: 0 - 16 Bar

Operating Temperature: 0 °C to +50 °C (at 10 bar)

Filtration Value: 30 µm

Flow Rate: 5000 L/min (P1=6 bar, v=25 m/s).

Efficiency: % 95

Discharge Method: Semi-automatic; can be automatic discharge upon request.

Test: Operating test is applied in compliance with MAG standards and ISO 5782 standard before delivering to each filter.

Technical Specifications of R 1" Regulator

Standards: ISO 6953 Regulator standard

Inlet Pressure: 0 - 16 Bar
Outlet Pressure: 0,5 - 9 Bar; optionally 0,3 - 6 and 0,6 - 15 bar.

Operating Temperature: 0 °C to +60 °C (at 10 bar).

Minimum Pressure Difference: P1 - P2 = 0,2 bar

Flow Rate: 5000 L/min (P1=6 bar, v=25 m/s).

Test: Operating test is applied in compliance with MAG standards and ISO 6953 standard before delivering to each regulator.

Technical Specifications of Y 1" Lubricator

Standards: ISO 6301 Lubricator Standard
ISO VG 32 Class MAG special air preparation unit lubricator should be used.

Operation Pressure: 0 - 16 Bar

Operation Pressure: -20 °C to +50 °C (at 10 bar).

Air-Oil Mixing Ratio: Can be adjusted with adjusting screw.

Flow Rate: 5000 L/min (P1=6 bar, v=25 m/s).

Test: Operating test is applied in compliance with MAG standards and ISO 6301 standard before delivering to each lubricator.

Warranty and Service:
MAG MFRY series conditioners are under the warranty of our company for 2 years against manufacturing defects. Also, service and spare part support is provided for 10 years.
Service and repair activities must be performed by MAG personnel. In the cases of any damage which may occur during assembly of the product to system and any intervention on product made by persons other than MAG personnel for the purpose of repair and maintenance, the warranty of product is cancelled.